haibao1
stainless steel strip
hose clip
hose fastening
guangjiaohuihengban1

Aug . 08, 2024 10:16 بیرته لیست ته

How to use stainless steel hose clamps



  1. First, place the stainless steel hose clamp in your hand, place one end of the hose on the tube and the other end on the other end of the tube.
  2.  Place the end of the hose on the end of the tube with your fingers and squeeze it hard to make the end of the larynx fit snugly with the end of the tube.
  3.  Use a screwdriver to fix the screws of the stainless steel hose clamp on the tube to ensure a tight fit between the hose and the tube.
  4. After installation, gently flick the hose clamp with your fingers to confirm the tight fit between the hose and the tube, and if there is any looseness, you can tighten the screws again.

شریکول

Jul . 05, 2024 15:30 بیرته لیست ته

How to use stainless steel hose clamps?



How to use stainless steel hose clamps?

1.Definition and Structure 

A stainless steel hose clamp is a type of pipe fitting used for piping system connections, usually consisting of two half-rings and a set of bolts. Stainless steel hose clamps have the advantages of corrosion resistance, high temperature resistance, and good sealing, so they are widely used in pipeline systems in food, pharmaceutical, chemical and other industries.

2.Second, the installation steps

(1)Place the two half-rings at both ends of the pipe, so that the hose clamp is aligned with the pipe, and pay attention to the positioning of the half-ring.

(2)Use bolts to tighten the two halves tightly, paying attention to the moderate strength, so as not to cause deformation or rupture of the hose clamp.

(3)Check whether the hose clamp is installed firmly and whether there are any leaks and other problems.

3.Factors that affect the quality of the installation

(1)The hose clamp shall not have defects such as pores, sand holes, shrinkage cracks, etc.

(2)The material and performance of the sealing ring must meet the requirements, and there shall be no bubbles, impurities, cracks, uneven and uneven defects on the sealing surface, and aging rubber rings shall not be used.

 (3)The moving distance of the clamp ring in the clamp is theoretically half of the expansion and contraction amount of the joint, and the actual amount should be measured, if it cannot be reached, it cannot meet the expansion and contraction requirements of the pipeline. In order to promote the sealing effect, the left and right end pipes are matched with clamps before leaving the factory, and the ordinary pipe should not be used to directly replace the end pipe in the actual project, and the perpendicularity of the end pipe end face and the axis and the flatness of the end face itself have certain requirements, and the expansion and contraction of the joint is greatly reduced if the size is not standard, and the use requirements cannot be met.

(4) The size of the diameter of the end pipe should be positive, otherwise the compression force of the clamp on the sealing ring is not enough, which will affect the sealing effect of the joint.


شریکول

که تاسو زموږ د محصولاتو سره علاقه لرئ، تاسو کولی شئ خپل معلومات دلته پریږدئ، او موږ به ډیر ژر له تاسو سره اړیکه ونیسو.


psPashto